“Corps”45 pages
- p. 40 …debris, sometimes along
with his Counter Intelligence Corps (CIC) subordinate, Lewis Rickett, who, like
Marcel, is…
- p. 45 …assembly) were located at the Army
Signal Corps Museum at Fort Monmouth and were obtained. A…
- p. 75 …and a Counter Intelligence Corps Officer, Sheridan Cavitt,
went to the ranch to inspect the material…
- p. 105 …Colonel Oliver LaFarge, Air Reserve Corps,
at Santa Fe, made atrangernents for Colonel Blanchard to visit…
- p. 159 …or unlawful inducement. ~
~I was a Counterintelligence Corps (CIC) Special Agent for the US Army AU…
- p. 163 …the Army Air Corps... right.
RW: When did you get transferred to Roswell, Sir?
SC: I…
- p. 166 …activity
like that, I was Counter Intelligence Corps, this didn't have anything to do with…
- p. 168 …There was nobody else out there from CIC or
Counter Intelligence Corps that you knew of…
- p. 169 …did, in the Air Force; the Air Corps. I think they wanted to ... they were having…
- p. 170 …six) "was an agent in the counterintelligence corps. He accompanied another
intelligence officer on the initial…
- p. 172 …Not
that you personally did, but the Army Air Corps in general: "The trip to the…
- p. 213 …Previously, I was
appointed as the laboratory chief in the Signal Corps as an Air Force…
- p. 214 …Some of the contractors lined up were not quite in concert with typical Signal
Corps practices…
- p. 217 …One of the individuals,
Sheridan Cavitt, who at that time was a Counter-Intelligence
Corps officer…
- p. 224 …Colonel Duffy was assigned to
extract meteorological.equipment out of the Signal_Corps in 1943.
There…
- p. 225 …Colonel Duffy talked to the field
artillery that was procuring through the Signal Corps, gun-laying…
- p. 236 …During WWII, the
·signal Corps had laid on them the requirement to develop a
constant level…
- p. 246 …V-2s and
other rockets the Ordnance Corps people were flying over at White
Sands. So…
- p. 264 …I knew the Signal Corps designation, the SCR-584s and
270-s, etc., but this was…
- p. 268 …We talked with the Signal Corps up at Fort Monmouth and
that's where we got…
- p. 274 …I was an Air Force officer
assigned to the Signal Corps as part of Colonel Duffy…
- p. 277 …Signal Corps and Army Air Force?
A: All the officers that I had on my staff…
- p. 278 …It was the Signal Corps' responsibility to procure those targets;
it was not the responsibility of…
- p. 279 …He got into a considerable amount of, shall we say, controversy with the Signal Corps
because…
- p. 299 …a) US Army Signal Corps Museum, Ft Gordon GA
Mr Ted Wise, Director, DSN 780-2818…
- p. 318 …Maj J~sse
Marcel, and two Counterintelligence Corps Agents, Capt Sheridan Cavitt and
MSgt Lewis Rickett…
- p. 320 …Liaison Officer to the US
Army Signal Corps, with primary duties for securing meteorological equipment
from…
- p. 517 …A modified radiosonde-type aneroid pressure capsule (Signal
Corps ML 310-/) has been the basic sensing…
- p. 519 Corps ML-310/ radiosonde aneroid unit, a metal helix on a
rotating cylinder of insulating material…
- p. 731 …Army Air Corps Stratosphere Flight
of 1934 in the Balloon 'Explorer'", Contributed Tec~ical Papers of…
- p. 761 …4· Richard Hassard, a forEr Signal Corps Officer was hired
because ot his general knowledge of…
- p. 763 …Griffith
11/7/II:> Visking Corp.
Chicago, Ill.
Mr. Cahn
12/4/11:> Visking Corp.
Chicago…
- p. 764 12/16/46 Celanese Celluloid Corp.
180 }ladison J, venue
New York, ~i. i..
12/17…
- p. 765 …Smith
1/3/47 Visking Corp.
Chicago, Ill.
Att: J. L. Lane
1/8/47 Watson…
- p. 766 …1/21/47 Shellmar·Projects Corp.
Mt. Vernon, Ohio
1/21/47 Milprint Inc.
Milwaukee, Wise…
- p. 767 …toPermission withheld.
place subcontract with
Unexcelled Chern. Corp.
for the fabrication of
be.lloons.
Request th…
- p. 768 …J •
3/7/47 Plax Corp.
Hartford, Conn.
Mr. R. E• .Ames
Same recuest as letter…
- p. 769 3/19/47 Unexcelled Chem. Corp.
New Brunswick, N.J.
Att: 2~r. Tegen
3/';:1…
- p. 781 …Plastics & Packaging No
1-f.J.lwa.ukee 1, Wisconsin
Celanese Plastics Corp. Plastics & Packaging No…
- p. 783 …As the motor switched modulator ~us already i~ experimental
state of manufacture for the Signal Corps…
- p. 810 …date, talked to Lt Dyer of Signal Corps regarding for tomorrow
firing. Chantz and Bill went…
- p. 811 …Delayed trip to Silver City to talk over Signal Corps
Communication with Peoples, Ball this PM…
- p. 812 …Left Alamogordo about 9 am, Chantz, Porter and myself, 2 Signal Corps
men along. Stopped at…
- p. 908 …As presently designed, the modulator contains a
standard Signal Corps ML-310E radiosonde aneroid
unit, a…
- p. 981 …Army Signal Corps, Saipan, in
1944. Photo Courtesy of Mrs. Emily Duffy.
Dr. Athelstan F. Spilhaus…
The effect of this cooling is evidenced in the lifting
power or the gas. When a rapidly filled balloon is launched
immediately after inflation, it has less lift than de-
sired and may even be "heavy" rather than buoyant. 20°C
cooling will make balloon 1% heavier. This may be 25%
of free lift. In the inflation of the 70-foot balloons
where more gas is used, and the cooling effec-t is more
often harmful, a heating unit is added to the inflation
equipment. The gas passes from the manifold through a
coil which is centrally wa~ed by a blow torch and on into
the inflation tube. The gas should arrive in balloon no
more than 20°C cooler than the air.
VI. BALLOON LAUNCHING
When the balloon infle.tion is complete, the inflatio:r;1 tube
is removed from the balloon as gently as possible. There
is apt to be constriction at the point where the bubble is
formed by the launching arms or the shot bags. If the tube
does stick at this point, great care must be given to freeing
without ripping the ball.oon.
Should the balloon be torn in this or any other manner, it
may be possible to patch the fabric and salvage the flight.
The acetate-fiber scotch tape, used to attach the batten is
used for patching. Transverse tapes are laid across the tear
and the entire region is covered with a matting of tape.
When the inflation tube is freed and the restrained bubble
is ready for launching, the lower portion or it is laid out
down wind, as is all of the gear on the load line. The in-
flation is generally done in the lee or the hangar or "Y"-
shaped wind screen (see Figures 28 and 29) with the bubble
as close to the wall as possible. It is imperative that the
wind direction be noted prior to launching and that the equip-
ment be directly downwind from the head of the bubble. It is
strongly recommended that a standard meteorological rubber
balloon be inflated and tethered on a 150-foot line near the
point of release to serve as a wind indicator. This balloon
is much more effective than a standard wind vane.
All pieces of equipment and all on-lookers must be removed
from the immediate vicinity to prev6nt accidental entanglement
of the load line when the balloon begins to rise. Each piece
of delicate gear to be carried aloft should be cradled by
one man. As a signal given by the flignt director (after
checking to see everyone is ready and that the balloon will
go in the desired direction), the bubble is released (see
Figure 30). If "launching arms" are used, this is not
-47-