“small beings”49 pages
- p. 17 …Others remain nonbelievers or
at least skeptical of the existence of alien beings and elusive vehicles…
- p. 19 …Moreover, operational necessity required that these balloons be launched during daylight
hours. It was therefore not…
- p. 30 …This has since grown from a minimal amount of debris recovered from
a small area to…
- p. 35 …This included, for example, a small
amount of missing "decimal files" from the 509th Bomb Group…
- p. 36 …This was a small section of the July Historical Report for the 509th Bomb Group
and…
- p. 37 …To believe that such operational and high-level security activity could be
conducted solely by relying…
- p. 39 …The foil-rubber material could not
be tom like ordinary aluminum foil can be tom... "
Sally…
- p. 40 …Although there does not appear to be much dispute that
Cavitt was involved in the material…
- p. 43 …Lt Col Cavitt described a small area of debris which appeared, "to
resemble bamboo type square…
- p. 72 …being per:ormed on these bodies.
The bodies were described as the body of a small…
- p. 99 …It should be noted that the period from approximately 1946 to 1950 is the least well…
- p. 105 …Several small projects were completed during ~1e mont.~ includine
signs on all the·office doors, a…
- p. 149 …Streett 1s
office recaumends against it on the ground that that is a
small enterprize down…
- p. 159 …I do not recall the incident being mentioned again as being any big
deal and I…
- p. 201 …We even simulated a small lightning strike over dry snow (just
from the snow blowing over…
- p. 258 …Big plastic
balloon with small auxiliary plastics," etc. "Watson Lab and
gear." "Followed" (inaudible) "receiver until…
- p. 261 …explain bodies or material that can't be
folded) by a sledge hammer.
Q: Let's…
- p. 328 …The witnesses have recalled small pink/purple "flowers" that appeared I to be
some sort of…
- p. 401 …b7 how ra*
the receiver •7 be re110ve~ .t'rows the pre~er. red height withqut…
- p. 443 …geostrophic wind (the latter being
derived under certain simplifying assumptions) and since the
geometry of the…
- p. 458 …Two designs which compro-
mise extreme cost (required for balloons of high internal pressure)
with small…
- p. 479 …This means that several hours might be required to fall through
the lanes of aircraft traffic…
- p. 484 …The change in drag effect may be realized by a decrease of
relative size of the…
- p. 487 (a)
Then:
(9)
or for small temperature differences:
(10) : - _L (.AI.)1-B T
the nega…
- p. 490 …gas of a balloon can be lost by:
leakage through small holes in the fabric or…
- p. 491 …for l:n•y small section of altitude is assumed
to be constant); and re.J…
- p. 506 in the preceding, section on diffusion end leakage the appendix
opening should be small. It can…
- p. 521 …is li~ited as indicated
above, small variations may be detected with the result
that it…
- p. 555 …being exposed about 10 hours
at cold temperature. (:S) During the floating period :many small oscilla…
- p. 565 …The very usef.ul information about be.llast flow was reported clearly, and
the principle of…
- p. 566 …Since the small external appendix with cardboard stiffeners was not
suitable for the large balloon, a…
- p. 580 …Following the initial activation at about 38,500 feet, small oscillations were
introduced into the flight…
- p. 614 …Figure 4 shows this appendix construction on a General M lls balloon which
is being inflated…
- p. 652 …At high altitudes, a difference of 40°C may
be expected in the temperature of the…
- p. 658 …To facilitate handling of the
line segments each length is prepared with a small hook on…
- p. 672 signals may be arranged so as to consume a very
small portion of -transmission time.
D…
- p. 738 …These values may
be compared with a diffusion loss of lift of the order
of magnitude…
- p. 742 …The constancy of level will be better the lower the
diffusion and the lower, therefore, the…
- p. 762 …te
.::mrcht:.se of small item£. A furth..:r rec:uest ~s been subr:rl tte…
- p. 783 …be of such a valve that
with a large r~diosonde frequency variation for a small…
- p. 785 …It is expected that this
equipment will be flown about 8 l-1ay. A description of…
- p. 815 …Before gear could be recovered, most of it had be~~tolen. Stations operating
at north hanger…
- p. 842 …Range started to slowly increase as did elevation with azimuth being
stationary. The echo remained beyond…
- p. 862 …By using this
stressed tape design, much larger loads may be carried than
the thin polyethylene…
- p. 874 …At this point, two small holes about
18" apart have been made, and the rip line…
- p. 881 …If thodolite stadia determinations are being
made, the banner can be used as one of the…
- p. 898 …laid out, A small amount of gas at very low pressure
Should be valved into the…
- p. 910 …The motor gears may be cleaned with
carbon tetrachloride and a small clean brush.
If the…
- p. 918 …Each combination of dots or dashes may be identified
by ear, and with a calibration chart…
OPERATIONS MANUAL
I. INTRODUCTION
A. Purpose of Manual
This manual is designed to serve as a guide in the prepar-
ation. launching. and tracking operations of constant-
level balloons. In the body of this manual, most of the
discussion applies specifically to the 20-foot diameter
balloon developed by General Mills, Inc. In Section IX,
a brief description is given of the other sizes of balloons
used for constant-level flight. The manual is based upon
the experiences and investigations of the Constant Level
Balloon Project, Research Division of the College of Engineer-
ing, New York University. The charta and tables which were
developed to use for this work are included in Appendix II
of the manual.
B. Principles of Altitude Control
For constant-level work, non-extensible balloons are used
for three reasons:
(l) With a given weight of equipment, it is possible to
determine before the release of the balloon, the
maximum altitude Which will be attained.
(2) Without special control equipment, it is possible
to maintain a nearly constant altitude for periods
from one to six hours, depending upon atmospheric
conditions and floating level. Generally, it is
not possible to extend such flights through a sun-
set.
(3) By adding altitude control equipment, it is possible
to maintain the balloon at various nearly constant,
predetermined levels for periods of much more than
six hours regardless of the time of day.
II. GENERAL MILLS 20-FOOT BALLOONS
A. Description
General Mills, Inc. of Minneapolis, Minnesota, has de-
veloped a series of non-extensible, plastic balloons.
These balloons are tear-drop in shape, made from extruded
polyethylene sheet, 0.001" thick. Cells are currently
produced.with a diameter of 7, 20, 30 and 70 feet. The
-7-