“descended”48 pages
- p. 326 …The fact it descended there was not unusual. Over the course of Project MoGUL,
several balloons…
- p. 427 …This switch completes a circuit through a relay operated
ballast valve whenever the balloon system descends…
- p. 429 …Whenever the balloon
system subsequently descends past control altitude~ ballast
is made to flow, maintaining the…
- p. 441 …When the system again descends to 2.5 11 ()(X), the pen arm comes into
contact…
- p. 445 …ft.) to float for another
hour before descending.
The advantages of this type .t'light for…
- p. 468 …on ascent; as the balloon began to descend to a region
ot higher pressure. a minimum…
- p. 472 …oration of the electrolyte) and the balloon descends, simple
displacement control becomes effect when the high…
- p. 473 …Then, with both controls operating, bilast
will flow only on the descending and floating portions of…
- p. 479 …rapid descent
after the balloon system has descended to some critical value, say
20,000 feet…
- p. 480 …Through this rupture, the lifting gas can es-
cape, and the balloon descends, using the upper…
- p. 490 …If a system in equilibrium in the stratosphere were to lose lift
and descend. the compression…
- p. 538 …Released trom .Alamogordo, New Mexico, 0509 MST, July 2, 1947
Descended at Cloudcroft, Hew Mexico
Using…
- p. 548 …will not cause the bal-
loon to descend as long as the remaining buoyancy is equal…
- p. 549 …seen descending 18 hours after release.
Figure 13
balloons probably
several hours, as
One balloon was…
- p. 557 …The finder
reported seeing the balloon descend 35 hours after release.
Sinoe the ballast flowing to…
- p. 558 …The .001" polyethylene balloon
was observed descending 22 hours later a.f.ter traveling mo!"e…
- p. 562 Fligllt 6~z Released from Alamogordo, New Mexico, 1116 MST, Kay 13, 1948
Descended at Alamogorde…
- p. 570 …A ballast meter
waa in use, and no ballast flow was recorded until the balloon descended…
- p. 572 …S.T.)
Figure 34
Since the balloon ttid not descend far enough below its maximum altitude…
- p. 573 …N.M.- 0511 MST, 10 AUG 1948
DESCENDED AT ROSWELL,N.M.- 1630 MST, 10 AUG…
- p. 576 …Figure 38
the balloon was slowly descending, the temperature of the gas increased with
respect to…
- p. 580 …Flight 90,
since the balloon had already descended to the activation level of the auto-
matic…
- p. 583 …one hour of floating
it began to descend at an accelerating rate. After falling about 2000…
- p. 585 …In this system, ballast flow was excited at any
altitude if the balloon descended at a…
- p. 591 …Figure 51
the balloon continued to descend. In both cases the token ballast f'low on…
- p. 632 …the train will descend. Although this method was used in early experimental
flights it proved to…
- p. 640 …Sealed in with the squib, which is fired
electrically ~hen the cell descends below 20.000…
- p. 665 …In flight 7,
however, the cluster rose till the lifters were cut off, descended until
sufficient…
- p. 667 …14,000
feet from which it slowly descended. Since the blowout patch was set to
act…
- p. 668 …known to have lasted for ten hours, descending
at Marietta, Oklahoma.
Flight 22, included an earlier…
- p. 669 …It was observed descending 50 miles north of
Toronto, Ontario, Canada, 14 hours later. ihe average…
- p. 670 …at 50,700 feet and began to
descend immediately. Flight 38 (see figure 55) was observed…
- p. 713 …the
Universit,y that balloons have been descending outside of the area in the vicinity
of…
- p. 715 …When the balloon descends to 20-000 feet, it not in the clear,
positions will be…
- p. 725 …VIas it observed descending? If so. when?
4. Di_d it float dawn slowly or fall…
- p. 736 …The only provision
for having the system regain altitude if it descended
too low was by…
- p. 738 …open to the atmosphere until the
balloon descends from a minimum pressure ..-\t this
time, an…
- p. 739 …ft where it leveled off,
then slowly descended to 9000 ft due to diffusion
losses. At…
- p. 740 …For the ballast valve to function, the balloon had to
descend to a pressure which would…
- p. 741 …When the original 2700-gram ballast was expended,
the balloon descended rapidly. Even had the auto…
- p. 777 …e which drops ballast whenever the
balloon descends below a preset altitude.
The specifications for the…
- p. 778 …Once the balloon sta.rtE descending (due to loss
of hydrot;en by diffusion or by…
- p. 784 …The remaining train thereupon descended as fast as it
bad climbed (1,000 ft. per minute…
- p. 870 …After reaching maximum altitude, the balloons
all exhibit a tendency to float then descend at an…
- p. 874 will cause the balloon to descend. Third, as a consequence
of the previous limi te.tion…
- p. 878 …WHEN THE BALLOON DESCeNDs THE PEN ARM RIDES
DOWN ON CoMMUTATOR UNDER THE SHELF, CLOSING THE…
- p. 892 …Was it observed descending? If so, at what timet
4. Did it float down slowly or…
- p. 988 …Due to the prevailing westerlies, MOGUL balloons often
descended in the vicinity of Roswell after launch…
A third method of holding the equipment at a nominal constant
altitude is to fly a cluster of standard meteorological balloons equipped
with ballast dropping devices and a device for releasing lifting balloons
should the cluster depart from the altitude limits desired. This method
is inherently unstable, as there are no proportioPAl restoring forces which
will act on the flabb,y, freely extensible meteorological balloons. The
success of this procedure depends on very careful balancing of the load
against the variable lift of the balloons.
This cluster method is of use and interest only as a stop-gap
method of lifting the Army equipment to altitude now, and has been the
method used while awaiting delivery of the non-extensible plastic balloons.
III d) e. A flight was made on 3 April 1947 using this method. A
cluster of 12 balloons meteorological carrying a radiosonde, a 15 lb.
d~ load and a series of ballast dropping devices was released from
the foo~ball field at Lehigh University, Bethlehem, Pa. The train was
to be towed to 30,000 ft. by' 2 lifting balloons which would then be
cut loose. The weight of the equipment was adjusted to equal the lift
of the balloons and presumably the train should have floated after the
towing balloons were cut off. Actually, due to lack of experience in
the difficulty of handling long balloon trains, auxiliary rigging lines
were needed to take up launching stresses. These lines fouled the main
flying line and the ballast which was to be dropped on parachutes. As a
result, the balloon train went to 50,000 ft. where the tow balloons worked
themselves free. The remaining train thereupon descended as fast as it
bad climbed (1,000 ft. per minute), landing in the ocean near Sandy Hook,
- 26 -