Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 539 …Too muoh weight was lost in this action, and the train rose until aome of the…
  • p. 540 …Train, Flight 10 The balloon rose to about 16,000 teet MSL and dropped back to…
  • p. 554 …It will be seen that the balloon rose~ a ' .. --------- r- ....., ..:. Pon"'m j"'.,.._" k '~I I…
  • p. 572 …obtained, but during this time the balloon rose with predicted speed (500 feet per minute) nearly…
  • p. 585 …On the other hand, the balloon rose extremely slowly and may have taken in air to…
  • p. 665 …In flight 7, however, the cluster rose till the lifters were cut off, descended until sufficient…
  • p. 739 …As a result, the cluster rose to ceiling and stayed at this altitude for a short…
  • p. 786 s4cond cluster flight, provision was also made to release balloons if the train rose above 40…
On completion of the survey of balloon materials other orders
l-rill be ~.)le..ced for experimental intE:rmediv te bB.lloons.
As soon as a series of ~uccessful flights are obtained, it is
?lanned to procure balloons of about 8 times the displacement of the inter-
mediate size for tests ~s the model to solve the problem. These larger
balloons would be about 30 feet in diameter.
Altitude Control
Mr. Goudy of the Kollsman Instrument Division of Square D Corpora-
tion was contacted to determine the feasibility of:
(1) An accurate pressure-actuated liQuid ballast dropping device.
(2) A motor-switched modulator for the standard Army radiosonde
AN/SMT-1. The standard pressure-switched modulator would be of little
vs.lue in determining the height of the constant level balloon s.fter it
leveled off on a constant pressure surface.
On a subcontract Kollsman undertook to build a pressure actuated
"dribbler" or ballast dropping device as follows:
Mechanically Controlle~ Dribbler
To consist of a diaphre.gm opera ted needle valve which will allow
no flow for a 2 mb. increase in pressure on the diaphragm over pressure
of which diaphragm is sealed but will allow a flow of 40 grams/minute
under 1 foot of lead for a 5 mb. increase in pressure. Petroleum ballast
with a density of about .775 gm/cc is to be used.
Diaphragm to be open to the atmosphere until it is sealed off
by the radiosonde pressure switch at a preset altitude.
- 24 -

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.