Documents / FOIA release
roswell
Office of the Secretary of Defense · 993 pages · text from the file's own layer
The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.
“Pound”31 pages
- p. 28 …In all, he estimated, the
entire lot would have weighed maybe five pounds. There was no…
- p. 231 …It was
like a 500 pound rack with a receiver, frequency meter, recorder,
etc., and we…
- p. 233 …About one pound.
A: correct. And the targets are nominally maybe a quarter
of a pound…
- p. 238 …They went
and got a whole bunch of soo pound bombs out of the Earl
Ammunition…
- p. 258 …Third balloon with two and a half pound stick of TNT and cap set
by pressure…
- p. 263 …releasing
something like maybe several hundred 500 pound bombs for this.
At the same time, Trakowski…
- p. 323 …I 4 inches wide, and weighing 13
pounds (Atch 4). The sonabuoy contained both the acoustical…
- p. 379 …have weighed maybe five pounds.
rancher living 30 mlles south. east bright wreckage made up on…
- p. 408 …six (6) scientists and twelve (12) thousand pounds of' equipnent from BElliAR,
NEV; JERSEY to KWAJALErn…
- p. 475 …Dry ice consumption at -GOOF is approxi-
mately 150 pounds for a 24-hour period.
It…
- p. 483 …is free lift in pounds
and G is gross lift in pounds.
Although this equation was…
- p. 536 …New Mexico
In this flight, a 65-pound load was lifted with a linear array of…
- p. 538 …and
tour larger lifting balloons, a 53-pound load was carried alott on this flight.
At…
- p. 542 …wall) to
lift • total load of S5 pounds as high aa posaible (Figure 7). 'lbe small…
- p. 588 …the
AM-1 transmitter (with about 10 pounds of batteries) was received for about
400 miles…
- p. 608 …Buoyer.cy per Pound Mol of GaS••••••••••••••••••••••••••••••••l6
V. Glossary of Term•••••••••••••••••••••••••••••••••••••••••••••21
VII. Summary of…
- p. 614 …foot balloon should be held tinder 30 pounds; 2) ratEBot
rise should be less than 900…
- p. 621 …of 50,000 feet, with a
30-pound payload, risea about 900 feet with each kilogr…
- p. 641 …Given: (l) The pound molar volume of any gas at standard
conditions=359 ft. 3
- 15 -
- p. 642 …2370 fte3
273.2 126
This is the mean pound molar volume at 15 km for…
- p. 643 …foot diameter,
at an altitude where the pound molar volume is 1000 ft. 3 (This is…
- p. 715 …Suspended
from the balloon is a 100 foot one thousand pound test nylon line which carries…
- p. 736 …The solid-ballast system was complex; approxi-
mately 900 pounds of sand was used on each…
- p. 737 …It
has an ultimate tensile strength of 1,900 pounds per
square inch at 2SC, which…
- p. 780 …for attaching rigging lines supporting a
~5-pound load to bottom of balloon ~nd means for…
- p. 862 …Yii th a 20•foot General Mills balloon, using helium, a
payload of 40 pounds will…
- p. 868 …Thus, if a 40-pound load is to be lifted, it is
not safe to use…
- p. 889 …This is the volume of a pound mol of any gas at those condi-
tions.
By…
- p. 893 …Elliptical shot bags, weighing 100
pounds,are used to hold the base of the bubble to…
- p. 907 …using
15 pounds (7 kilograms) of batteries. Longer periods
of transmission may be achieved by intermittent…
- p. 984 …The detonation, or "shot" (right), of 500 pounds of TNT
was monitored at White Sands Proving…
altitude as it has no further buoyancy. This altitucie stability
exists only as long as the balloon is in the fully inflated or
"taut" state. Once the balloon sta.rtE descending (due to loss
of hydrot;en by diffusion or by other loss) ii:i becomes flabby and
is no longer ~table. It will continue descerrling until corrective
action is taken or until it reaches the earth.
The altitude control is to be used is the ballast valve. When
correctly set it will determine the lower limit of .the be.lloon' s oscill~tion
as it would release a free flowing liquid ballast from a reservoir whenever
the balloon descends a short distance below a preset altitude.
To test this tentative solution to the basic problem, inter-
mediate sizes of balloon made of suitable fabric or films c.re needed in
addition to the altitude controls.
Balloons
Balloon manufacturers and fabricators of plastic films were
contacted to locate a suitable balloon material. The following materials
were suggested:
Material
Plastic Film
Polyethylene
Saran
Advantages
Good low temperature
properties (Gen.l{ills
desires to fabricate
Picard's balloons
from this).
Transparent, low
permeability, high
tensile strength.
Disadvantages
Low tensile strength,
Milky-translucent,
Medium permeability.
Tears easily, fair
low temperature pro-
perties (?),weak at
seams if heat sealed.
- 20 -
Disposition
10 ea. 15 ft.
balloons being
fabricated from
it.
5 large ~lloons
being fabricated. About this file
FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.