Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 51 …Kopelson said the office's investigation, first reported in the Albuquerque Journal yesterday, stemmed from a…
  • p. 82 …northwest ofHobbs NM 7 miles southeast of Albuquerque NM Carrizozo NM 15 miles southwest of Alamogordo…
  • p. 176 …of command that reported to Kirtland in Albuquerque rather than Fort Worth and although Blanchard outranked…
  • p. 225 …Tibbetts, who until recently lived in Albuquerque, he's now moved to Scottsdale, Arizona. Tibbetts says…
  • p. 273 …Another fellow recently came into view, a Carl Pflock from Albuquerque, New Mexico. He appeared to…
  • p. 299 …B-29 crashed on T/0 from Albuquerque in Jan 1947 and a B-29 crashed…
  • p. 379 …but h.e thought the constru~t.ion. ~;ent here from the Albuquerque wondered if what…
  • p. 543 …reports. Reports from .l!il Paso, Roswell. Albuquerque and White Sands were used for comparison with…
  • p. 637 …WNW-5 W-7 10,000 M Albuquerque 1944 SE-3 W-3 W-6 W…
  • p. 639 …3 wsw-2 WNW-5 'WNW-8 Albuquerque 1944 N-3 "WNW-4 WNW-6 W…
  • p. 723 …representative preaeurea and temperatures taken from Washington, Albuquerque, Pittsburgh and Lakehurst soundings. Individual variations from season…
  • p. 740 …was reported to have been seen over Albuquerque, New Mexico, and about 26 hours later a…
  • p. 742 …Over Albuquerque, which was considerably farther from the path of the balloon than the other two…
  • p. 788 …The .altitudes corresponding to various molar volumes for Lakehurst am Albuquerque in January and in August…
altitude as it has no further buoyancy. This altitucie stability
exists only as long as the balloon is in the fully inflated or
"taut" state. Once the balloon sta.rtE descending (due to loss
of hydrot;en by diffusion or by other loss) ii:i becomes flabby and
is no longer ~table. It will continue descerrling until corrective
action is taken or until it reaches the earth.
The altitude control is to be used is the ballast valve. When
correctly set it will determine the lower limit of .the be.lloon' s oscill~tion
as it would release a free flowing liquid ballast from a reservoir whenever
the balloon descends a short distance below a preset altitude.
To test this tentative solution to the basic problem, inter-
mediate sizes of balloon made of suitable fabric or films c.re needed in
addition to the altitude controls.
Balloons
Balloon manufacturers and fabricators of plastic films were
contacted to locate a suitable balloon material. The following materials
were suggested:
Material
Plastic Film
Polyethylene
Saran
Advantages
Good low temperature
properties (Gen.l{ills
desires to fabricate
Picard's balloons
from this).
Transparent, low
permeability, high
tensile strength.
Disadvantages
Low tensile strength,
Milky-translucent,
Medium permeability.
Tears easily, fair
low temperature pro-
perties (?),weak at
seams if heat sealed.
- 20 -
Disposition
10 ea. 15 ft.
balloons being
fabricated from
it.
5 large ~lloons
being fabricated.

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.