Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 28 …In all, he estimated, the entire lot would have weighed maybe five pounds. There was no…
  • p. 231 …It was like a 500 pound rack with a receiver, frequency meter, recorder, etc., and we…
  • p. 233 …About one pound. A: correct. And the targets are nominally maybe a quarter of a pound…
  • p. 238 …They went and got a whole bunch of soo pound bombs out of the Earl Ammunition…
  • p. 258 …Third balloon with two and a half pound stick of TNT and cap set by pressure…
  • p. 263 …releasing something like maybe several hundred 500 pound bombs for this. At the same time, Trakowski…
  • p. 323 …I 4 inches wide, and weighing 13 pounds (Atch 4). The sonabuoy contained both the acoustical…
  • p. 379 …have weighed maybe five pounds. rancher living 30 mlles south. east bright wreckage made up on…
  • p. 408 …six (6) scientists and twelve (12) thousand pounds of' equipnent from BElliAR, NEV; JERSEY to KWAJALErn…
  • p. 475 …Dry ice consumption at -GOOF is approxi- mately 150 pounds for a 24-hour period. It…
  • p. 483 …is free lift in pounds and G is gross lift in pounds. Although this equation was…
  • p. 536 …New Mexico In this flight, a 65-pound load was lifted with a linear array of…
  • p. 538 …and tour larger lifting balloons, a 53-pound load was carried alott on this flight. At…
  • p. 542 …wall) to lift • total load of S5 pounds as high aa posaible (Figure 7). 'lbe small…
  • p. 588 …the AM-1 transmitter (with about 10 pounds of batteries) was received for about 400 miles…
  • p. 608 …Buoyer.cy per Pound Mol of GaS••••••••••••••••••••••••••••••••l6 V. Glossary of Term•••••••••••••••••••••••••••••••••••••••••••••21 VII. Summary of…
  • p. 614 …foot balloon should be held tinder 30 pounds; 2) ratEBot rise should be less than 900…
  • p. 621 …of 50,000 feet, with a 30-pound payload, risea about 900 feet with each kilogr…
  • p. 641 …Given: (l) The pound molar volume of any gas at standard conditions=359 ft. 3 - 15 -
  • p. 642 …2370 fte3 273.2 126 This is the mean pound molar volume at 15 km for…
  • p. 643 …foot diameter, at an altitude where the pound molar volume is 1000 ft. 3 (This is…
  • p. 715 …Suspended from the balloon is a 100 foot one thousand pound test nylon line which carries…
  • p. 736 …The solid-ballast system was complex; approxi- mately 900 pounds of sand was used on each…
  • p. 737 …It has an ultimate tensile strength of 1,900 pounds per square inch at 2SC, which…
  • p. 780 …for attaching rigging lines supporting a ~5-pound load to bottom of balloon ~nd means for…
  • p. 862 …Yii th a 20•foot General Mills balloon, using helium, a payload of 40 pounds will…
  • p. 868 …Thus, if a 40-pound load is to be lifted, it is not safe to use…
  • p. 889 …This is the volume of a pound mol of any gas at those condi- tions. By…
  • p. 893 …Elliptical shot bags, weighing 100 pounds,are used to hold the base of the bubble to…
  • p. 907 …using 15 pounds (7 kilograms) of batteries. Longer periods of transmission may be achieved by intermittent…
  • p. 984 …The detonation, or "shot" (right), of 500 pounds of TNT was monitored at White Sands Proving…
132
BALLAST INI.IT TUBE
FIG. 2.. \utomatic ballast valve.
a diaphragm-operated needle valve which jettisons
liquid ballast whenever the balloon is below the alti-
tude at which the control is actuated. This is shown in
fig. 2. The ballast reservoir (fig. 3), in general, can
hold 15 kilograms of the liquid ballast-usually com-
pass fluid, a highly refined kerosene-type petroleum
product. When the atmospheric pressure outside the
diaphragm is 5 millibars above the internal pressure,
160 grams of ballast per minute flow under a one-foot
head. When the automatic ballast valve is wide open,
which is after 6.5 millibars increase over the internal
pressure, 300 grams per minute flow. These values may
be compared with a diffusion loss of lift of the order
of magnitude of 10 grams per hour from the thicker
15-ft balloon described below. Quite positive altitude
control can be obtained.
Efforts are made to cause the static rate of leakage,
i.e., the leakage which proceeds when the automatic
ballast valve is closed, to exceed slightly the rate of
loss of lift due to the diffusion of the lifting gas from
the balloon. To facilitate setting the fixed leak, a
manually operated ballast valve, consisting of a leak
adjustable by means of a fine needle valve, is added to
the ballast-release assembly. 4
C. lJ;finimum pressure switch.-0bvious1y, the auto-
matic ballast valve must not be in operation while the
balloon is rising, as this would be a waste of ballast.
Therefore the automatically operated needle valve is
closed until the balloon reaches altitude. This is ac-
complished by having the loaded diaphragm of the
altitude control open to the atmosphere until the
balloon descends from a minimum pressure ..-\t this
time, an electrical contact is made and a squib6 cuts a
' Since this manuscript was written, the procedure has been
simplified. Only a simple fixed leak is used for daytime flights.
The automati~ ballast valve is used alone for Rights through
sunset or sunnse.
1 A small electrically detonated charge.
VoLUME 5
restraining cord and allows a needle valve to seal off
the diaphragm from any further access to the air
(fig. 2). The capsule then contains a volume of air
which has been trapped at the existing pressure an'd
temperature, at the time of operation of the sealing
switch. Thereafter the aneroid will withdraw the
ballast-control needle valve when the ambient pressure
increases to the point where the entrapped air is com-
pressed below this volume.
Fig. 4 shows the minimum pressure switch which
makes the electrical contact at the time of seal-off. It
consists of a trapped volume of air that is allowed to
escape through a mercury pool as long as the outside
pressure is decreasing. As soon as the exterior pressure
increases once more, however, mercury is drawn into
the tube, making the seal-off contact between two
electrodes.
4. Height determination
Up to the present time, the standard radiosonde has
been used in order to determine the altitude at which
the balloon is flying. This permits a regular radiosonde
ascent to be obtained during the period that the bal-
loon is rising. Thereafter, as the balloon remains at
approximately the same altitude, it becomes somewhat
difficult to identify the radiosonde contact, but utiliz-
ing both the temperature and pressure indication, this
is possible. A special radiosonde modulator of the
Olland type has been designed (fig. 5). The pressure
BATTERY BOX
VENT TUBE
DISCHARGE TUBE
FIG. 3. Ballast-release assembly.

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.