Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 28 …In all, he estimated, the entire lot would have weighed maybe five pounds. There was no…
  • p. 231 …It was like a 500 pound rack with a receiver, frequency meter, recorder, etc., and we…
  • p. 233 …About one pound. A: correct. And the targets are nominally maybe a quarter of a pound…
  • p. 238 …They went and got a whole bunch of soo pound bombs out of the Earl Ammunition…
  • p. 258 …Third balloon with two and a half pound stick of TNT and cap set by pressure…
  • p. 263 …releasing something like maybe several hundred 500 pound bombs for this. At the same time, Trakowski…
  • p. 323 …I 4 inches wide, and weighing 13 pounds (Atch 4). The sonabuoy contained both the acoustical…
  • p. 379 …have weighed maybe five pounds. rancher living 30 mlles south. east bright wreckage made up on…
  • p. 408 …six (6) scientists and twelve (12) thousand pounds of' equipnent from BElliAR, NEV; JERSEY to KWAJALErn…
  • p. 475 …Dry ice consumption at -GOOF is approxi- mately 150 pounds for a 24-hour period. It…
  • p. 483 …is free lift in pounds and G is gross lift in pounds. Although this equation was…
  • p. 536 …New Mexico In this flight, a 65-pound load was lifted with a linear array of…
  • p. 538 …and tour larger lifting balloons, a 53-pound load was carried alott on this flight. At…
  • p. 542 …wall) to lift • total load of S5 pounds as high aa posaible (Figure 7). 'lbe small…
  • p. 588 …the AM-1 transmitter (with about 10 pounds of batteries) was received for about 400 miles…
  • p. 608 …Buoyer.cy per Pound Mol of GaS••••••••••••••••••••••••••••••••l6 V. Glossary of Term•••••••••••••••••••••••••••••••••••••••••••••21 VII. Summary of…
  • p. 614 …foot balloon should be held tinder 30 pounds; 2) ratEBot rise should be less than 900…
  • p. 621 …of 50,000 feet, with a 30-pound payload, risea about 900 feet with each kilogr…
  • p. 641 …Given: (l) The pound molar volume of any gas at standard conditions=359 ft. 3 - 15 -
  • p. 642 …2370 fte3 273.2 126 This is the mean pound molar volume at 15 km for…
  • p. 643 …foot diameter, at an altitude where the pound molar volume is 1000 ft. 3 (This is…
  • p. 715 …Suspended from the balloon is a 100 foot one thousand pound test nylon line which carries…
  • p. 736 …The solid-ballast system was complex; approxi- mately 900 pounds of sand was used on each…
  • p. 737 …It has an ultimate tensile strength of 1,900 pounds per square inch at 2SC, which…
  • p. 780 …for attaching rigging lines supporting a ~5-pound load to bottom of balloon ~nd means for…
  • p. 862 …Yii th a 20•foot General Mills balloon, using helium, a payload of 40 pounds will…
  • p. 868 …Thus, if a 40-pound load is to be lifted, it is not safe to use…
  • p. 889 …This is the volume of a pound mol of any gas at those condi- tions. By…
  • p. 893 …Elliptical shot bags, weighing 100 pounds,are used to hold the base of the bubble to…
  • p. 907 …using 15 pounds (7 kilograms) of batteries. Longer periods of transmission may be achieved by intermittent…
  • p. 984 …The detonation, or "shot" (right), of 500 pounds of TNT was monitored at White Sands Proving…
When the contact is made, the load line is cut and the entire
weight of the dependent equipment is used to pull out a section of
the balloon wall. Through this rupture, the lifting gas can es-
cape, and the balloon descends, using the upper portion as a para-
chute. The rate of descent has been observed to vary from 600 to
1500 feet per minute when this system is employed.
For some special applications it has been desirable to cause the
balloon to descend after some predetermined time, instead of waiting
for the descent to air traffic lanes. In these cases, a clockwork
switch has been used instead of the pressure-activation unit. ~ben
docks are used they are kept free of lubricants which will freeze.
The best results have been obtained from the use of a Dow Corning
Silicone (DC 701) diluted with 30% kerosene. If this is not
available, it is better to send up a clock without any lubrication.
Given relatively loose mechanism (a cheap alarm clock) the differ-
ential expansion of parts which is encountered at low temperatures
is apt to cause less trouble than does the congealing of standard
lubricants.
IV. EQ.UATIOOS AND TF..EORETICAL CONSIDERATIONS
Development of a controlled altitude balloon has led to investigation
of many theoretical considerations applicable both directly and in-
directly to the description of variables encountered in balloon control.
Some of these relationships have been derived directly from standard
hydrodynamic or thermodynamic principlesJ others come from an empirical
study of results of laboratory tests and actual balloon flights. In
this section we will investigate these theoretical considerations and
endeavor to correlate them with actual flight results. A more simple
investigation of the equations necessary for the launching and tracking
of a controlled altitude balloon is contained in Part II of this report,
"Operations."
We shall first consider the relationships which aid in evaluating the
elementary characteristics of non-extensible balloon flight and those
which are helpful in carrying out inflation and launching operations
of such balloons. Next, we shall discuss more complex considerations
involved in balloon flights.
A. Floating Altitude and Altitude Sensitivi5Y
To determin& the altitude at which a non-extensible balloon will
float we must consider the weight of the balloon system, the volume
of the belloon, and the densities of the lifting gas and the
air. [If the lifting gas is 98% helium (molecular weight
4.50 lb./lb. mol), the lift of a unit of gas will be 24.4 lb./lb. mol.
Similarly, if 98% hydrogen were the lifting gas, the lift would be
26.6 lb./lb. mol.] By using these three basic parameters, we can
obtain an expression for the molar volume at which the balloon will
float:
-30-

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.