Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 218 …remember these which would make the thing rotate in flight. But this, in the B models…
  • p. 418 …Specltically, he le resnonaible tor tuperv1t1on of the Rotating ~gine Branch and the lon-lotating Encine…
  • p. 428 (Type E preferred) J a rotating commutator ot two segments, an insulator and a conductor; a…
  • p. 519 Corps ML-310/ radiosonde aneroid unit, a metal helix on a rotating cylinder of insulating material…
  • p. 521 …However, this error was minimized by the smoothness of the rotating cylinder and the continuous motion…
  • p. 523 …The performar.ce specifications are as follows: (a) Rotation: one revolution every 12 hours (b) Duration…
  • p. 528 …is recorded by the pen on a rotating smoked drum {B) • In order to prevent the…
  • p. 558 …and as evidenced by the barogram in Figure 20 (12-hour rotation). the balloon maintained its…
  • p. 560 …From the barogram (Figure 22) (12-hour rotation) it appears that the orifice did not permit…
  • p. 671 …and with four turns on a helix rotating once a minute, the pressure read- ability of…
  • p. 908 …This contact is used as a reference point for measuring the speed of rotation of the…
  • p. 910 (b) gears or poor alignment of the rotating cy- linder. The motor gears may be cleaned…
  • p. 911 pending upon the speed or rotation of the mo- dulator motor. The pressure signal appears at…
  • p. 915 …These values may be detected by carefully observing the rate of rotation of the motor, which…
  • p. 916 change in motor speed of five percent or more from the preceding rotation, the pressure value…
  • p. 917 …When rotating e. t about l rpm duration of signals not over 3 to 4 seconds…
  • p. 920 …The recording dr~ rotates once in twelve hours. Therefore, it a :flight lasts over twelve hours…
  • p. 922 …In smoking the drum a long rod is used as a rotating axis. The drum is…
  • p. 923 …The rotation of the drum is once in 12 hours and, therefore, the time-distance relation…
PROFESSOR MOORE - 6/8/94 6
Q: w.w. Brazel mentions eyelets which appear in the
reflectors. There's also, on the polyethylene balloons, the
shroud however you had it hooked on there. There's eyelets
around the base. There was a ring at the neck of the balloon and
then there were attach points to that ring, were there not?
A: But there were no eyelets.
Q: I believe there were. I've reviewed the New York
University documents and there's a very clear depiction in one of
them of eyelets.
A: Okay, I was thinking of the later ••• Here are the NYU
reports, the originals of them.
Q: In one of the configurations they clearly show eyelets
in the drawing.
Q: Going back to Brazel, you state that you think it could
not be one of the polyethylene balloons. He indicates in this
newspaper article that he actually found the debris in mid-June,
however it didn't subsequently come out until July.
A: You're right. That is in one of the polyethylene
balloons, you're correct. I fall back on my plea that my memory
isn't ...
Q:
about.
It comes into depending on what Brazel was speaking
A: There are clearly eyelets here. In fact there's a
little swivel.
He talks about the smoky gray rubber ••.
Q: Which these samples here, as you say, if they'd only
been out for a short time, a matter of days, smoky gray, that's a
very good description of what they looked like.
A: And when you first retrieve it has a bad odor. And
people talked about there being a burned odor.
We need to talk about these neoprene balloons because they
came in different ..• There were two manufacturers-- one, Dewey
& Olney in Cambridge manufactured with a dip process and they had
very much the appearance, if you will, of a condom. They were an
ivory colored jell. The Kaysam company in Patterson made a cast
neoprene emulsion into a mold~ and then they inflated the mold.
They had to put a lot of plasticizers so they could take this wet
jell and inflate it and make it into a meteorologic balloon.
This is a Kaysam balloon here, which I think is not a good
candidate.
Q: Kaysam?

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.