Documents / FOIA release

roswell

Office of the Secretary of Defense · 993 pages · text from the file's own layer

The Roswell Report: Fact versus Fiction in the New Mexico Desert was published in 1995 by Headquarters United States Air Force. It was written in response to Representative Steven H. Schiff's request and a General Accounting Office audit, and it contains Col. Richard L. Weaver's report and 1st Lt. James McAndrew's synopsis, along with attachments, appendices and photographs. The report says researchers found no evidence of an extraterrestrial craft or crew. It concludes that the 1947 debris came from a Project MOGUL balloon train.

  • p. 218 …remember these which would make the thing rotate in flight. But this, in the B models…
  • p. 418 …Specltically, he le resnonaible tor tuperv1t1on of the Rotating ~gine Branch and the lon-lotating Encine…
  • p. 428 (Type E preferred) J a rotating commutator ot two segments, an insulator and a conductor; a…
  • p. 519 Corps ML-310/ radiosonde aneroid unit, a metal helix on a rotating cylinder of insulating material…
  • p. 521 …However, this error was minimized by the smoothness of the rotating cylinder and the continuous motion…
  • p. 523 …The performar.ce specifications are as follows: (a) Rotation: one revolution every 12 hours (b) Duration…
  • p. 528 …is recorded by the pen on a rotating smoked drum {B) • In order to prevent the…
  • p. 558 …and as evidenced by the barogram in Figure 20 (12-hour rotation). the balloon maintained its…
  • p. 560 …From the barogram (Figure 22) (12-hour rotation) it appears that the orifice did not permit…
  • p. 671 …and with four turns on a helix rotating once a minute, the pressure read- ability of…
  • p. 908 …This contact is used as a reference point for measuring the speed of rotation of the…
  • p. 910 (b) gears or poor alignment of the rotating cy- linder. The motor gears may be cleaned…
  • p. 911 pending upon the speed or rotation of the mo- dulator motor. The pressure signal appears at…
  • p. 915 …These values may be detected by carefully observing the rate of rotation of the motor, which…
  • p. 916 change in motor speed of five percent or more from the preceding rotation, the pressure value…
  • p. 917 …When rotating e. t about l rpm duration of signals not over 3 to 4 seconds…
  • p. 920 …The recording dr~ rotates once in twelve hours. Therefore, it a :flight lasts over twelve hours…
  • p. 922 …In smoking the drum a long rod is used as a rotating axis. The drum is…
  • p. 923 …The rotation of the drum is once in 12 hours and, therefore, the time-distance relation…
PROFESSOR MOORE - 6/8/94
not leave any creases. This material looks like it would almost
be like aluminum foil, would crease and remain creased.
A: It does have this paper laminate, and the paper, I
think, was maybe a bit tougher on the earlier thing. But I have
no explanation for the fact that it couldn't be bent with a
sledge hammer, as one of the people said, and couldn't be .••
Q: Burned?
A: I think some of the balsa wood was dipped in something
like Elmer's glue, and as a result had some sort of a glue
coating on it which would make it somewhat resistant to burning.
3
Q: I know in Colonel Weaver's discussions with Sheridan
Cavitt, they talked about the aspect of burning. He did not
recall burning anything, but then his wife indicated that there
had been one night they'd been out and had a barbecue and had a
few beers and that Jesse Marcel just took a piece and stuck it in
the barbecue and then pulled it back out. So if that's what
they're using to say it wouldn't burn, that's what we consider
typically testing a material for burning or not.
A: I need to say here, you need to qualify everything I
say with the memory of almost 50 years ago. I will say things
that are to the best of my memory, but on the other hand, should
other evidence indicate my memory is faulty, I readily accept
that. So I'll state things to the best of my memory, but ••.
I have a memory that there was something like Elmer's
glue ... There was a problem in attaching this to the paper
behind.
Q: Going back to the reinforcing tape and things, there
were discussions concerning unusual symbols and almost .like
hieroglyphics -- purple, pinkish in nature, that sort of thing.
A: I don't know if I sent Colonel Weaver a copy of the
sketch.
Q: No, we did not see that.
A: Robert Todd, who has been a person very interested in
trying to get to the truth of this, asked me to make a sketch of
what I remember. A couple of years ago, or a year or so ago, I
made this sketch, and this is my memory of what was there.
I do remember every time I prepared one of these targets for
flight, I always wondered why these figures were on the tape.
There was always a question of why they were there. When this
purplish-pink marking on the debris came up, I immediately
remembered this sort of marking. Other people, I have a letter
here from one of my technicians, who says oddly he remembers the
same marking. You, perhaps, have talked to Albert Trakowski ••.

Cases discussed

About this file

FOIA release, from the osd collection. The PDF is mirrored here; the original link is under it. 993 pages are in the text index: search them above, or from the library's search.