“BEAMS”43 pages
- p. 5 …Sketch of Two Opposite Limits of the Beam·Maxwellian Equilibrium .. 38
Figure 4.5. The Definition…
- p. 6 …Comparison of Analytical and Numerical Estimates of Q-Values in a
Beam-Dominated Solution -- for a…
- p. 8 …shows the "Star
Mode" discharge where ion beams are created that pass through the grid openings…
- p. 9 …discussed later where the recirculating ions possess
beam-like trajectories passing through the center of the…
- p. 10 UNCLASSIFIED/ ;raA 8FFIIItliL ~81!! SHL'f
beam-like ions. Since electron energy loss processes such as…
- p. 11 …In addition, its beam-like reactions (highly non-Maxwellian)
make the IEC very well suited for…
- p. 13 …a beam created at the anode and accelerated by the applied cathode
voltage; a low-energy…
- p. 14 …Good convergence is required to achieve
optimal beam-beam reactivity scaling for the application that require…
- p. 15 …The observed
loss of convergence with decreasing pressure and increasing current makes achieving
significant beam-beam…
- p. 16 …For a power reactor the objective is to obtain ion
beam-beam collisions in this central…
- p. 17 …the "conventional" beam-like
one. A key issue for this concept is how much plasma compression…
- p. 19 …The
main beam observed is a direct path along the injector
angle. Other faint light channels…
- p. 21 …Note that six ion "guns" were used to create a low energy ion beam that entered…
- p. 22 UNCLASSIFIED/;SflHl 8FFIIItliL ~81!! 8HL'I'
was obtained from recirculation beam-beam reactions in a potential…
- p. 23 …The key physics point is
that the beam-beam fusion rate scales as the ion current…
- p. 26 …Scoping calculations of beam-background fusion rates predict that a 3 He- 3 He reaction
product…
- p. 27 …of the ion density squared
scaling for beam-beam reactions.
REFERENCES
2.1 R. L. Hirsch…
- p. 28 …As such, the beam convergence (compression) is
limited to lower values, hence lower core densities (an…
- p. 30 …by
the intersection of the multiple ion beams, serves to deflect ions into the escaping jet…
- p. 31 …The result is the
formation of the intense space charge neutralized ion beam (or "plasma jet…
- p. 32 …in the
symmetric microchannels into a directed beam or jet.
Comparison to a Conventional "Plasma" Thruster…
- p. 33 …The ion beams finally exit through an opening in the ground sphere of the IEC device…
- p. 35 …These devices operate with ~ 80- keV D-ion beams using the non-Maxwellian
character of the…
- p. 36 …Two ion sources inject
40-keV deuterium and helium-3 ion beams toward the center of…
- p. 37 …Indeed in this case fusion is dominated by beam-beam (non-
Maxwellian reactions). Also, the dipole…
- p. 38 …the center potential and consequently allow incoming
beam ions to penetrate into the core region. In…
- p. 39 …Comparison of Analytical and Numerical Estimates of Q-values in
a beam-Dominated Solution -- for a…
- p. 40 …Hora, "Converging Beam Neutron Source for
Driving a Sub-critical Fission Reactor", Proceedings, ICONE 8, CD…
- p. 41 …Namely, the time scale for
collisional degradation of the beam-like ion distribution function is crucial…
- p. 42 …For example, a tightly focused monoenergetic ion beam is in
fact a pessimistic scenario, because different…
- p. 44 …Thus, weak sinks and strong sources will result in a
large beam population, increasing the beam…
- p. 45 …Sketch of Two Opposite Limits of the Beam-Maxwellian Equilibrium. The solid line
corresponds to a…
- p. 46 …injected beam current, average injection energy, energy spread associated
with the velocity component in both parallel…
- p. 47 …As stated in Section I, the current scaling
for beam-beam reactions is strictly 12. However…
- p. 48 …is very encouraging for formation of deep wells
in IEC devices designed for reactors using beam…
- p. 49 …To do this, it is
assumed that the electrostatic confinement equilibrium ion beams are proportional to…
- p. 50 …When an ion beam is hot, the waves excited by the instability are ion acoustic
type…
- p. 51 …Rider was particularly interested in the claim that due to its beam-like non-
Maxwellian plasma…
- p. 52 …Diagram Showing Equipotential
Surfaces of the IEC Cathode Grid and Their
Focusing Effect on a Beam…
- p. 59 …of detectors, the detector configuration, the collimated
beam size, the acquisition time, and other scan-related…
- p. 63 …Alternately, for space
propulsion, the proton beam, augmented by injection of heavy atoms to increase the…
- p. 68 …Due to its inherent non-Maxwellian (beam-like)
plasma, the IEC is especially well suited for…
- p. 70 …This configuration is highly
non-Maxwellian due to the beam
dominated nature of the trapped ions…
UNCLASSIFIED/,·, Ok err1e1111t "91!! &HEY
0
- o'
Q Q ' - :,
5 ~--7. , •-. : •,'
gi-t~;-~~- - ~!_;<-:_4.~.:-~tJ??'·,' _.:
c~~ --- 3(/8-
me
[a] rbl
lei ldl
Figure 4.3. Plot of the Q-value (including electron losses) as a Function of (a) Sma, and y with fe= 10·3 ,
(b) Smax and fe with y =5, (c) Sma. and fe with y =100, and (d) Smax and Eo with y= 5 and fe =10-3 • These
plots have been obtained for Eo =100 keV [except (d)], 9b =0.01, and E, =l.04. (Nomenclature is defined in
Reference 4.2).
The source to sink issue noted several times here can be explained as follows. Two
opposite limits of this kind of solution are depicted in Figure 4.4. The realization of
either of these limits depends on the equilibrium between two competing effects,
namely up-scattering of the Maxwellian ion component confined in the well (which
increases as the Maxwellian temperature increases and tends to empty the well), and
down-scattering of the beam (which tends to fill it). The relative importance of these
effects is directly related to the strength relatives of the source and the sink. They are
characterized here by Smax = maximum value of the ion source, and t = ion
replacement time, respectively. Thus, weak sinks and strong sources will result in a
large beam population, increasing the beam down-scattering rate and hence increasing
"effective" Maxwellian temperature, given in the dotted line profile in Figure 4.4.
Conversely, weak sources and strong sinks will result in a small beam population, thus
decreasing the beam down-scattering rate and resulting in lower Maxwellian
temperatures, leading to the solid line profile in Figure 4.4.
37
UNCLASSIFIED//FQA: QFFI&lal k I l&'i Qllk¥