Documents / Document

Apollo 11 Technical Crew Debriefing, Volume 1 (scan)

NASA via ibiblio · 1969-07-31 · 251 pages · text by OCR

This is Volume 1 of NASA's Apollo 11 Technical Crew Debriefing, dated July 31, 1969. The Mission Operations Branch of the Flight Crew Support Division at the Manned Spacecraft Center in Houston prepared it, and it was originally classified Confidential. In it Armstrong, Aldrin and Collins go phase by phase through suiting, launch, powered flight, Earth orbit and lunar surface activities. They comment on suit fit, vibration, checklists, lunar dust, footing and poor sleeping conditions in the lunar module. A section titled Visual Sightings appears in the table of contents.

  • p. 15 …LIGHTS ARMSTRONG Launch vehicle lights, roll program, pitch program, roll complete were on time, as were…
  • p. 41 …Then, just as in the simulator, the DAP rolled itself out. It ceased its pitch rate…
  • p. 43 …I did have a slight roll misalignment. I knew I had a slight roll misalignment, but…
  • p. 48 …It definitely had a good roll to it moving away. ## CONFIDENTIAL
  • p. 63 …roll angle is unconstrained in that with large trunnion angles, the computer may pick a roll…
  • p. 64 …being furnished to me in regard to roll angles. However, I didn't. That's one…
  • p. 65 …What they meant was that the spacecraft did not have to be rolled in such a…
  • p. 66 …very large, and you have an obvious roll on its alignment in the reticle, then it…
  • p. 79 …We always used 0.3 deg/sec roll and we never tried the 0.1. It…
  • p. 111 …There is a constraint on 2-jet roll, 4-jet roll, and no-jet roll, depending…
  • p. 150 …While flying AOT, you depend on the other crewmember to assure you that the roll gimbal…
  • p. 158 …It was then that I clearly realized that we weren't rolling as fast as was…
  • p. 216 …The part that had been melted, separated, and rolled back or peeled back on the secondary…
  • p. 224 …d know what is inside a certain roll. In many cases, there is nothing in it…
  • p. 227 …When it rolled up, it had a tendency to sneak off to the side and crinkle…
  • p. 247 …Also, I could roll over on one side or on the other. I had the two…
  • p. 248 …more horizontal position or the capability to roll from one side to the other. That's…
## CONFIDENTIAL

uncomfortable for a couple of hours with the UCD pushing into my crotch area. This problem goes back to that first suit fit at the factory. ILC is very concerned about the mobility inside a pressurized suit, and I think they went a little bit overboard in cutting that thing on the tight side. I didn't really put the UCD on; you know what I mean. They've got a house UCD up there, and you sort of slap that inside the suit and then you get a fit check. The only time it hurt me was when I actually had the UCD securely held and I was strapped into the couch and my legs were up. The only thing I could suggest is that when anybody goes to the factory, they take their own UCD and put the damn thing on and, during that fit check, go through some kind of an imitation of the watch position with the correct leg-to-body angle which you have in that couch for launch position. Put your own UCD on and see whether that's going to be comfortable or not. I fiddled and diddled with it between CDDT and launch, and it was still fairly uncomfortable for launch; for CDDT, that damn thing almost did me in. Don't let them cut the suit too tight, and try to get a good fit check at the factory.

## CONFIDENTIAL

About this file

Document, cited by the archive. The PDF is mirrored here; the original link is under it. The text was read from the page images by an OCR model; expect the odd misread word. 251 pages are in the text index: search them above, or from the library's search.