Documents / Document

Apollo 11 Technical Crew Debriefing, Volume 1 (scan)

NASA via ibiblio · 1969-07-31 · 251 pages · text by OCR

This is Volume 1 of NASA's Apollo 11 Technical Crew Debriefing, dated July 31, 1969. The Mission Operations Branch of the Flight Crew Support Division at the Manned Spacecraft Center in Houston prepared it, and it was originally classified Confidential. In it Armstrong, Aldrin and Collins go phase by phase through suiting, launch, powered flight, Earth orbit and lunar surface activities. They comment on suit fit, vibration, checklists, lunar dust, footing and poor sleeping conditions in the lunar module. A section titled Visual Sightings appears in the table of contents.

Open the PDF at page 49 Original source ↗

“Roll”17 pages

  • p. 15 …LIGHTS ARMSTRONG Launch vehicle lights, roll program, pitch program, roll complete were on time, as were…
  • p. 41 …Then, just as in the simulator, the DAP rolled itself out. It ceased its pitch rate…
  • p. 43 …I did have a slight roll misalignment. I knew I had a slight roll misalignment, but…
  • p. 48 …It definitely had a good roll to it moving away. ## CONFIDENTIAL
  • p. 63 …roll angle is unconstrained in that with large trunnion angles, the computer may pick a roll…
  • p. 64 …being furnished to me in regard to roll angles. However, I didn't. That's one…
  • p. 65 …What they meant was that the spacecraft did not have to be rolled in such a…
  • p. 66 …very large, and you have an obvious roll on its alignment in the reticle, then it…
  • p. 79 …We always used 0.3 deg/sec roll and we never tried the 0.1. It…
  • p. 111 …There is a constraint on 2-jet roll, 4-jet roll, and no-jet roll, depending…
  • p. 150 …While flying AOT, you depend on the other crewmember to assure you that the roll gimbal…
  • p. 158 …It was then that I clearly realized that we weren't rolling as fast as was…
  • p. 216 …The part that had been melted, separated, and rolled back or peeled back on the secondary…
  • p. 224 …d know what is inside a certain roll. In many cases, there is nothing in it…
  • p. 227 …When it rolled up, it had a tendency to sneak off to the side and crinkle…
  • p. 247 …Also, I could roll over on one side or on the other. I had the two…
  • p. 248 …more horizontal position or the capability to roll from one side to the other. That's…
## CONFIDENTIAL

This was during the nonpropulsive part of the vent and you could see two streams coming out of either side as the oxidizer was vented out. Exactly opposite to each other were two cones going out. I guess the cones were 30 degrees out one side and 30 degrees out the other, so it was definitely observable.

COLLINS But something appeared to be wrong with the attitude they gave us. I don't know whether they miscalculated or what, but they gave us an attitude to see the slingshot out the hatch window. We confirmed that we were looking through the correct window, and it wasn't there.

## 5.35 S-IVB VENTING OPERATION

COLLINS I don't know what to say about that. I guess it went nor mally.

5. 36 PROPELLANT DUMP DURING SLINGSHOT MANEUVER

## ALDRIN

We didn't make use of that procedure of keeping we didn't use it to any advantage of having the other state vector keep track of the S-IVB. It sounds Mickey Mouse, but it could have been some assistance in telling us where the S-IVB was.

ARMSTRONG Yes.

# CONFIDENTIAL

Cited by

About this file

Document, cited by the archive. The PDF is mirrored here; the original link is under it. The text was read from the page images by an OCR model; expect the odd misread word. 251 pages are in the text index: search them above, or from the library's search.