“Works”60+ pages
- p. 6 …It released after a good bit of work and coordination between Mike and Fred, the BCMP…
- p. 7 …Our procedure worked very well. I don't know who thought it up to use the…
- p. 16 # CONFIDENTIAL
3.11 CABIN PRESSURE (DECREASE)
COLLINS The valves worked as advertised and started decreasing as…
- p. 17 …ALDRIN This would give you a clue if the lights were not working, if something had…
- p. 25 …L-2 and L-9 need some work to get them in the proper sequence.
ALDRIN…
- p. 28 …ARMSTRONG That worked well for us, I think.
COLLINS Worked fine.
ALDRIN Optics Cover Check.
COLLINS…
- p. 40 …and docking, in general, worked in flight just as it worked a couple of times in…
- p. 41 …In the simulator, sometimes it worked like magic and other times it wouldn't. In flight…
- p. 42 …ALIGNMENT AT 50 FEET
My procedure was worked out so I'd be 66 feet away…
- p. 46 …All that hardware worked well.
We followed the checklist. We extracted in CMC, FREE, and then…
- p. 51 …were quite reasonable and had been well worked out by previous crews and I'd recommend…
- p. 53 …That worked fine.
All three suits did go in the L-shaped bag satisfactorily and could…
- p. 54 …That worked as planned, and we think that's a reasonable procedure.
Folding them, taking a…
- p. 55 …3 OPTICS CALIBRATION
COLLINS Optics calibration worked all right.
6. 4 PHOTOGRAPHY; EARTH AND MOON
COLLINS…
- p. 62 …from that viewpoint, or it won't work properly. These are just two pitfalls that I…
- p. 68 …A little bit of work could have cleaned that up before the flight, and I just…
- p. 69 …safe and comfortable with it, and it worked throughout the flight.
6. 15 ADEQUACY OF PROCEDURES…
- p. 70 …all the P30's and P40's worked out very smoothly.
## 6.16 MIDCOURSE CORRECTION
## ARMSTRONG…
- p. 74 …It hasn't been well worked out. I feel uncomfortable about this.
ARMSTRONG It's just…
- p. 75 …just trying to see how it was working. All of a sudden we found that we…
- p. 77 …I suspected at times that it was not working properly. I never absolutely caught it mal…
- p. 78 …6.21 S-BAND SQUELCH
## ARMSTRONG
It worked very well, I thought.
## ARMSTRONG
## 6.22 DAYLIGHT…
- p. 79 # CONFIDENTIAL
## 6.24 RADIATORS
COLLINS We never flowed through the secondary radiators because the primary worked…
- p. 80 …ALDRIN When it worked, it worked like a charm. There were a couple of times when…
- p. 82 …The repetition just took the pressure off the next day's IVT.
## ALDRIN
Working in the…
- p. 83 …ARMSTRONG So, all in all, I guess it worked out well. We recommend it as a…
- p. 84 …We got a lot of rest and got into lunar orbit eager to go to work…
- p. 93 …That always worked for us. We were always able to see the star in the sextant…
- p. 103 …It seemed to work well.
ARMSTRONG I was thinking ahead about our overall LM stowage which…
- p. 110 …The probe, drogue, and hatch worked flawlessly. At this time, I was on this solo book…
- p. 115 …This solo book concept, where I had all the information I needed in one book, worked…
- p. 116 …I'm not sure it turned out to be any less work. I never was too…
- p. 117 …me to see that the system was working. We had no scheduled checks on it to…
- p. 120 …I think that things worked out quite well. We were gradually, comfortably getting 15 to 20…
- p. 122 # CONFIDENTIAL
ALDRIN (CONT'D) E-memory dump, and you did some work with the DSKY and…
- p. 123 …But, that worked out all right.
## CONFIDENTIAL
- p. 124 …If in other flights it could be worked into the earth-side pass, I think it…
- p. 127 …ALDRIN The S-band antenna seemed to work very well at this stage. It didn't…
- p. 129 …If it didn't work that way, when you moved it, it didn't go to…
- p. 132 …Cards worked quite well. We'd lose maybe a little bit of time by having to…
- p. 133 …The little piece of Velcro on the feet port worked quite well, just slapping it down…
- p. 140 …AUTO optics worked well, and the optics drive was extremely smooth. When using resolve and in…
- p. 141 …This technique works for another few miles, but I don't know how long I could…
- p. 143 …I did that as a VERB 49 maneuver, and it worked fine in that I had…
- p. 148 …This procedure seemed to work as we had planned; however, the variation in the data was…
- p. 149 …We had it worked out with the ground how we arranged the signs on the differences…
- p. 151 # CONFIDENTIAL
for the PDI needs additional work prior to the next flight.
There are some alternative…
- p. 154 …something that the two of us could work on at the same time and to give…
- p. 165 …That worked pretty well, but I was surprised that I had as much trouble as I…
- p. 174 …noticed that the mission timer wasn't working. It was frozen; it just stopped.
ARMSTRONG No…
- p. 175 …We turned it off for a while and turned it back on again and it worked…
- p. 176 …might have that we'd want to work on, and the second was our adaptation to…
- p. 177 …from the window prior to lunar surface work. We were in a relatively smooth area covered…
- p. 180 …We would have at least one working watch to back up the mission timer or to…
- p. 187 …It seemed to work well.
## 10.20 DEPRESSURIZATION
This was one area of flight preparation that…
- p. 188 …Well, in retrospect, it all seemed to work okay, it was just that we weren't…
- p. 190 …and the work on the ladder and the platform is that our simulation work in both…
- p. 191 …The work and effort required to go up and down the ladder and in through the…
- p. 193 …operation of lowering the camera seemed to work fairly well. It appeared as though you might…
- p. 196 …10.25 ENVIRONMENTAL FAMILIARIZATION
With respect to work on the surface, the 1/6 gravity was…
## CONFIDENTIAL
overheating. In confirmation of Neil's findings, I didn't experience any hot or even warm spots in the suit. I didn't wear any inner gloves, either, in my desire to get a better feel through the gloves. During the donning, I did not have the wristlets on. I thought that the LCG extending down far enough into the wrist would be adequate. If I had to repeat this effort, I would put the wristlets on, because once I was in the gloves and I started moving them around, I did find that it was rubbing a small amount on the wrist. I thought that it might get to be more annoying than it actually turned out to be, but looking back, I would have preferred having those wristlets on.
## 10.25 ENVIRONMENTAL FAMILIARIZATION
With respect to work on the surface, the 1/6 gravity was, in general, a pleasant environment in which to work, and the adaptation to movement was not difficult. I felt it was quite natural. Buzz had the opportunity to look at more detailed aspects of it, a good bit more than I did, but, in general, we can say it was not difficult to work and accomplish tasks. I think certain exposure to 1/6g in training is worthwhile, but I don't
# CONFIDENTIAL